67 lines
1.9 KiB
C++
67 lines
1.9 KiB
C++
#include <Arduino.h>
|
|
#include <Wire.h>
|
|
|
|
#include "R1NeoBoard.h"
|
|
|
|
#ifdef NRF52_POWER_MANAGEMENT
|
|
// Static configuration for power management
|
|
// Values set in variant.h defines
|
|
const PowerMgtConfig power_config = {
|
|
.lpcomp_ain_channel = PWRMGT_LPCOMP_AIN,
|
|
.lpcomp_refsel = PWRMGT_LPCOMP_REFSEL,
|
|
.voltage_bootlock = PWRMGT_VOLTAGE_BOOTLOCK
|
|
};
|
|
|
|
void R1NeoBoard::initiateShutdown(uint8_t reason) {
|
|
// Disable LoRa module power before shutdown
|
|
MESH_DEBUG_PRINTLN("R1Neo: shutting down");
|
|
digitalWrite(SX126X_POWER_EN, LOW);
|
|
|
|
if (reason == SHUTDOWN_REASON_LOW_VOLTAGE ||
|
|
reason == SHUTDOWN_REASON_BOOT_PROTECT) {
|
|
configureVoltageWake(power_config.lpcomp_ain_channel, power_config.lpcomp_refsel);
|
|
}
|
|
|
|
enterSystemOff(reason);
|
|
}
|
|
#endif // NRF52_POWER_MANAGEMENT
|
|
|
|
void R1NeoBoard::begin() {
|
|
// R1 Neo peculiarity: tell DCDC converter to stay powered.
|
|
// Must be done as soon as practical during boot.
|
|
|
|
pinMode(PIN_DCDC_EN_MCU_HOLD, OUTPUT);
|
|
digitalWrite(PIN_DCDC_EN_MCU_HOLD, HIGH);
|
|
|
|
// R1 Neo peculiarity: Tell I/O Controller device is on
|
|
// Enables passthrough of buttons and LEDs
|
|
|
|
pinMode(PIN_SOFT_SHUTDOWN, OUTPUT);
|
|
digitalWrite(PIN_SOFT_SHUTDOWN, HIGH);
|
|
|
|
NRF52BoardDCDC::begin();
|
|
|
|
// button is active high and passed through from I/O controller
|
|
pinMode(PIN_USER_BTN, INPUT);
|
|
|
|
pinMode(PIN_BUZZER, OUTPUT);
|
|
digitalWrite(PIN_BUZZER, LOW);
|
|
|
|
// battery pins
|
|
pinMode(PIN_BAT_CHG, INPUT);
|
|
pinMode(PIN_VBAT_READ, INPUT);
|
|
|
|
Wire.setPins(PIN_WIRE_SDA, PIN_WIRE_SCL);
|
|
|
|
Wire.begin();
|
|
|
|
pinMode(SX126X_POWER_EN, OUTPUT);
|
|
#ifdef NRF52_POWER_MANAGEMENT
|
|
// Boot voltage protection check (may not return if voltage too low)
|
|
// We need to call this after we configure SX126X_POWER_EN as output but before we pull high
|
|
checkBootVoltage(&power_config);
|
|
#endif
|
|
digitalWrite(SX126X_POWER_EN, HIGH);
|
|
delay(10); // give sx1262 some time to power up
|
|
}
|