The T1 has an ICM-42607-P IMU with the same address as a DS3231 RTC.
This completely breaks the clock on the T1. Reading the time results in
a garbage value, causing all sorts of strange issues. The time never
advances, which breaks logging in to repeaters (due to their time-based
replay protection).
This simply disables the probe on the I2C line. The DS3231 doesn't have
a WHO_AM_I register that could be used to prevent misidentifying it, so
this simpler fix is used.
thinknode_m8: initial support
adds some functionalities to ui_task and epddisplay:
epd display,
- supports screen off, and clear screen
- supports forcing full refresh every N partial refreshes (off by default, configured to 60 for M8)
ui_task
- UI_SHOW_CLOCK flag to display clock on first screen
- rotary button can act like joystick (with regards to Enter key), defaults to old config for existing nodes
- screen off on long press when using rotary button (very handy for the watch)
SPI pins that are set to -1 cause OOB reads on NRF52. The unused Serial2 pin definitions were removed to avoid potential issues with the Uart framework.
Setting SPI pins to values that are OOB of the g_ADigitalPinMap[] array causes OOB reads. This variant.h has pin 0 as 0xFF which passes through as NRFX_SPIM_PIN_NOT_USED.
PA PL1 re-targets the PA's DC-DC supply rail rather than selecting a
logic-level gain, and the serial CLI is serviced on every main-loop pass
regardless of whether a transmit is in flight. A `set radio.fem.txgain`
write could therefore move the rail mid-transmit, while the SX1262 was
still driving the PA at full input power.
Record the requested level in setPAGainEnable() and drive the pin from
setTxModeEnable(), which runs from onBeforeTransmit() ahead of
startTransmit(). The level only matters while transmitting, so deferring
costs nothing.
Document that the pref is saved immediately but applied at the next
transmit, so `get radio.fem.txgain` can lead the hardware until then.
Board manifest for esp32-c6-devkitm-1 defaults build.flash_mode to qio,
which this module's flash chip does not support -- causes a boot
crash-loop (repeated USB-Serial-JTAG reconnects) on real hardware.
Override with board_build.flash_mode = dio in the common M5Stack_Unit_C6L
section so it applies to all envs (ble/usb/repeater/room_server).
Alex Beal
liamcottle
ripplebizandGitHub
fdlamotteandGitHub
Rastislav Vysoky
Dominik Tyrala
taco
Huw DuddyandGitHub
entr0p1
Adam Gessaman
Hacuchino-hash
me