- Dead code gone: anim::fadeHide, radioctl::presetCount, the L2 board's
setSdPower / setGrovePower / expanderOK (awRead, gnssReset now private).
- buttonBar() / barButton() replace 7 copies of the popup button row.
- confirmBody(): one red-button confirm for reboot / power off, reset
counters, admin commands, preset and scope delete.
- tapConfirmed(): the 11 "tap again" buttons share one mechanism, 3 s
everywhere, the label restored when left alone.
- noteLabel() for ~30 wrapped notes.
- localTm() in NodePrefs.h and one MONTHS table: lvgl, MsgExpand, the L1
clock and lock screen.
- The sim keeps UI settings in an in-memory nvs::, so one set of load /
save helpers serves both.
- Asleep, the loop wakes every 50 ms (the button / touch poll), not 20.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Settings > Sound > Quiet hours (L2: its own group; L1: Quiet hrs / from /
until): from quiet_from to quiet_to (local hours, wrapping past midnight)
the buzzer is muted and a message doesn't wake the screen; the clock alarm
still rings. A manual mute or unmute inside the window stands until the
window ends. Off with the clock unset.
NodePrefs gains quiet_hours / quiet_from / quiet_to (appended to the file,
sentinel 0xC0DE0030; sizeof 2832 on nRF52 and ESP32), off by default,
22:00-07:00. hourInWindow() / localHour() are shared with the bot's quiet
hours. soundctl::tick() replaces autoTick() (Auto and quiet hours).
Also fixes the L2 side-button mute: it went by the mode, not by whether
the buzzer was muted, so with Auto + an app connected (and now quiet hours)
the first press muted instead of unmuting.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The Noise tab held the L2's interference hunt: parts of the board off one
by one, a slow cycle for a second radio, a spike hunt and three sweeps
(~90 s, L2 only). It is now one Measure: the noise floor on the mesh
frequency (median and 10th percentile of 5 s) and a +-1.1 MHz sweep round
it, ~12 s, with a short legend for reading it. Works wherever the variant
defines the radio.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The UI runs on Arduino's loop task, whose stock 8 KB stack had 340 B left
at its deepest point; a screenshot's file write went past it and reset the
device. The loop stack is now 16 KB (measured peak ~7.8 KB) and the
screenshot's line buffer is static. Diagnostics names the row
"UI stack free (lowest)".
With a cable in at boot, the USB popup waited for nothing and showed over
the splash; it now comes once the splash has faded.
Adds docs/development/plan-next.md, the plan up to the merge into dev.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
JakubandClaude Opus 5.5