- Dead code gone: anim::fadeHide, radioctl::presetCount, the L2 board's
setSdPower / setGrovePower / expanderOK (awRead, gnssReset now private).
- buttonBar() / barButton() replace 7 copies of the popup button row.
- confirmBody(): one red-button confirm for reboot / power off, reset
counters, admin commands, preset and scope delete.
- tapConfirmed(): the 11 "tap again" buttons share one mechanism, 3 s
everywhere, the label restored when left alone.
- noteLabel() for ~30 wrapped notes.
- localTm() in NodePrefs.h and one MONTHS table: lvgl, MsgExpand, the L1
clock and lock screen.
- The sim keeps UI settings in an in-memory nvs::, so one set of load /
save helpers serves both.
- Asleep, the loop wakes every 50 ms (the button / touch poll), not 20.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- USB through TinyUSB (ARDUINO_USB_MODE=0) instead of USB-Serial/JTAG: the
serial port stays, and plugged into a computer (enumerated, the bus not
suspended -- on battery an unplug only shows as a suspend) the device asks
"Charge only / USB drive". As a drive the firmware lets go of the card and
the computer gets its sectors; ejected or unplugged, the device restarts.
- Incoming messages: a banner slides down from under the status bar (icon,
sender or channel, two lines of the text from history); a tap opens the
conversation (not while locked), a swipe up dismisses it, not shown for
the conversation already open. Toasts moved up there too, under the banner
when both are up; the ones only echoing a switch or a choice are gone.
- Storage > Format card: a popup saying what goes, then Format tapped twice;
one FAT32 volume over the whole card (readable or not), then a restart.
- A deliberate restart shows a full "Restarting..." screen with the reason
instead of the screen just freezing.
- The screenshot flash is a thin frame round the edges: a full-screen fade
redrew all 320x240 each step and tore.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Every toggle / stepper wrote the prefs file straight away (0.1-0.6 s on the
ESP32's SPIFFS), which stuttered the UI and wore the flash. prefsSave() now
only marks them dirty; they're written once when the screen is left, when the
display goes off, or after 60 s at the latest -- the L1's approach. Shutdown
and the pre-restart OTA save still write immediately.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
group() / settingRow / listRow / actionRow / choiceRow / groupNote: one card
per section, hairlines between rows, hints that wrap. Dropdowns replaced by
a centred picker list. Settings regrouped (Device, Connections, Map & data,
System); Display & power split into Display, Power and Time on L2 only
(the shared schema is unchanged), Keyboard and About get their own pages.
Radio and Repeater share one LoRa parameter block.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Power: the UI loop sleeps until something is due (never with packets
queued); screen off puts the CPU at 80 MHz, the GT911 to sleep (unless a
tap wakes the screen) and the LP5814 in standby. GPS off now cuts the
L76K's rail and UART on the L2 (L2GpsProvider). The battery divider is
powered only for a reading (measured: settles at once); readings within
2 s are reused. The SD mount is retried at most every 5 s.
Fixes: WiFi left on after leaving a scan, live tiles' WiFi kept with the
screen off on the map, an ADC read every second for the status bar, touch
polled on every pass while dark, a scan cutting an update's WiFi, relay
count not refreshing in a channel thread, raw @[nick] in room previews.
Labels skip unchanged text (no redraw).
Helpers: scrollList, dimOverlay, settingRow, flexBox, nvs::get/put,
trailFilePath (a second save in the same minute no longer overwrites),
unreadTotal. Dead code removed.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Map tools hold trail, live share and arrival alert, with their options
(schema page "Map options") behind one button; back returns to the map
- Nearby gets an advert button: send now (nearby / everyone) + auto-advert
- Home page 3: Repeater, Admin (list of repeaters and room servers),
Diagnostics
- Settings: display, sound, radio (Bluetooth, WiFi), system, keyboard,
contacts & messages; units moved to Display & power
- Status bar: Bluetooth, GPS, alarm, mute, then auto-advert, trail, live
share, repeater, arrival alert in the accent colour
- Fonts: key and route glyphs
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- New env Wio_Tracker_L2_companion_solo_lvgl_v3 on pioarduino 55.03.312-1;
the 2.0.17 env stays until the new one passes the hardware checklist
- SerialBLEInterface: NimBLE variant (PIN pairing through encrypted,
authenticated characteristic properties; setAccessPermissions is a no-op)
- buzzer: i2s_std driver on IDF 5 (legacy driver kept for 2.0.17)
- ESPNOWRadio: IDF 5 callback signatures
- ui-lvgl: psramBuf() for trail drawing, tile cache, map marks, list rows,
keyboard maps and message metadata; internal heap back to 2.0.17 level
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
JakubandClaude Opus 5.5