Watchdog: nRF52840 hardware WDT with 30s timeout, runs during sleep.
Resets device if main loop stalls for >30s. Pets in every loop()
iteration so normal operation never triggers it.
QuickMsgScreen: new UI screen accessible from home screen pages.
Two-phase UI: contact picker (shows all contacts with hop count),
then predefined message picker (location, I'm OK, need help, on my
way, ETA 10min, ETA 30min). Location message uses live GPS fix if
available. Sends via the_mesh.sendMessage() and shows sent/error alert.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Save last known unix timestamp to /rtc_save on shutdown and restore it
on startup, so the clock shows correct time immediately after restart
without waiting for GPS fix.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- CPU sleep: board.sleep(0) in main loop puts NRF52 into WFE/sd_app_evt_wait
between iterations; wakes on any interrupt (radio, BLE, timer). Largest
power saving of the three changes.
- VBAT_ENABLE gating: voltage divider now powered only during ADC read
(HIGH for 10ms, then LOW). Previously stayed HIGH continuously.
Fixed in both variant.cpp (init) and WioTrackerL1Board::getBattMilliVolts().
- LED off with display: PIN_LED is cleared when auto-off triggers and
restored (handed back to userLedHandler) when display wakes. Avoids
idle LED current draw during screen-off periods.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- Remove extra blank line in companion_radio main.cpp before NRF52/STM32 block
- Revert unintended STM32_PLATFORM ETHERNET_ENABLED branch (no STM32 ethernet target exists, and it incorrectly included nrf52 headers)
- Drop renovate annotations from rak4631 platformio.ini (no renovate config in this repo)
* room server: added RegionMap, and new CommonCLI wiring, default_scope handling
* sensor: only minimal RegionMap wiring. Still needs work to handle default-scope
The companion_radio example was not restoring the GPS enabled/disabled
preference from flash after reboot. The preference was being saved
correctly when toggled via the mobile app, but on boot,
sensors.begin() -> initBasicGPS() unconditionally sets gps_active=false
and nothing subsequently restored the persisted state.
Added applyGpsPrefs() (matching the pattern in simple_repeater,
simple_sensor, and simple_room_server) and call it from main.cpp
after sensors.begin() to ensure the GPS hardware is initialized
before the saved preference is applied.
JakubandClaude Sonnet 4.6
Scott Powell
Quency-DandGitHub
Liam CottleandGitHub
tuzzmaniandevil
Rococo88
Wessel Nieboer
chrisdavis2110
Rastislav Vysoky
Quency-D
Ryan Gregg
terminalvelocity23
Scott Powell
Alejandro Ramirez