Resolve conflicts: keep both Ethernet CLI and SenseCAP power-off
button code in repeater, keep both Ethernet docs and power management
CLI docs.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Add #pragma once to SerialEthernetInterface.h
- Rename TCP_PORT to ETH_TCP_PORT with #ifndef guard
- Fix typos: "initalizing" → "initializing"
- Fix #elif without condition → #else for STM32 block
- Replace infinite loop on ETH init failure with halt()
- Remove heartbeat Serial.print(".") output
- Remove dead beginETH() call (ETH_ENABLED, not RAK_ETH_ENABLE)
- Comment out MESH_DEBUG and ETH_DEBUG_LOGGING build flags
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Add W5100S Ethernet adapter support for RAK4631-based firmware, enabling
TCP CLI access on port 23 as an alternative to BLE/Serial connections.
- New SerialEthernetInterface for nRF52 with DHCP, reconnection handling,
and shared WB_IO2 power pin management with GPS module
- Ethernet build targets for repeater, room server, and companion firmware
- Prevent GPS from toggling WB_IO2 when Ethernet module is active
- CI build check for all three ETH firmware targets
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Support for R1 Neo hardware. New variant and baseboard class.
* Known issues:
- power management is not currently supported
- power off via long button press is not implemented
Add support for Epson Seiko RX8130CE I2C Real-time clock.
Enable GPS time synchronization across all variants by passing
&rtc_clock to MicroNMEALocationProvider. When GPS gets a valid
fix, the RTC clock is now updated automatically every 30 minutes.
Updated 16 variants: rak4631, lilygo_tbeam_SX1262, rak_wismesh_tag,
lilygo_tbeam_supreme_SX1262, thinknode_m3, heltec_v4, thinknode_m1,
lilygo_tbeam_SX1276, meshadventurer, nano_g2_ultra, heltec_v3,
promicro, xiao_c3, heltec_tracker_v2, keepteen_lt1, heltec_mesh_solar.
Pin mapping verified against HTIT-Tracker V0.5 schematic:
- GPIO35 (GPS_EN): N-ch MOSFET drives P-ch high-side switch, active HIGH
- GPIO36 (GPS_RST): hardware reset, active LOW
- GPIO33/34: UART TX/RX
Delegates power management to MicroNMEALocationProvider begin()/stop()
which independently controls GPS power via GPS_EN and shares VEXT with
the display through RefCountedDigitalPin.
João BrázioandGitHub
whywilson
ripplebizandGitHub
Wessel Nieboer
Sybren A. Stüvel
Ryan GreggandClaude Opus 4.6
MGJandGitHub
Scott Powell
kelsey hudson
Ryan Gregg
Sam Schlegel
Confi
Liam CottleandGitHub
Quency-DandGitHub
Quency-D
Wessel Nieboer
Wessel NieboerandWessel Nieboer