gat562_30s_mesh_kit has an always-on external PA rated at +30dBm, but the
firmware wrote tx_power_dbm straight to the SX1262 register (capped at 22),
so the app/CLI/UI never matched the real radiated power and couldn't ask
for more than 22 even though the hardware supports it.
Add a generic, macro-gated PA gain-curve resolution in
RadioLibWrapper::setTxPower() (the single choke point every TX-power path
already funnels through), reusable by any future board with a similar PA.
For this board, reuse the vendor-measured 869MHz curve from the open
upstream Meshtastic PR that added it for the same physical module
(meshtastic/firmware#11212): pick the lowest SX1262 setting whose measured
output reaches the requested dBm, clamped at the PA's saturation knee.
Bump LORA_TX_POWER/MAX_LORA_TX_POWER to 30 for this variant only -- the
other three GAT562 boards use the SX1262's own PA_BOOST (22dBm, no
external PA) and are unaffected.
Since a request below the PA's floor gain (14dBm) still radiates at that
floor, also make CommonCLICallbacks::setTxPower() return what was actually
applied, and have every setter (BLE CMD_SET_RADIO_TX_POWER, CLI "tx",
simple_repeater/room_server/sensor) persist and report that value instead
of the raw request -- so tx_power_dbm never silently disagrees with the
physical output in either direction.
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
The `recv_pkt_region` is set when processing a flood packet in `filterRecvFloodPacket`
but direct/non-flood packets would never pass through that function, so the pointer was
not cleared for them.
`sendFloodReply` would then later use it blindly, which meant that the response would
either inherit the region from the last flood packet, or refer to a non-initialised pointer
if no region floods had been received yet.
* room server: added RegionMap, and new CommonCLI wiring, default_scope handling
* sensor: only minimal RegionMap wiring. Still needs work to handle default-scope
This change counts when readData returns an err code other than RADIOLIB_ERR_NONE. In most cases this is going to be a CRC error. This counter is exposed in the `stats-packets` command, and in the repeater stats payload (4 additional bytes to the payload, which is now 56 bytes with this change. My incompetent robot claims the total payload size is 96 bytes (unverified but probably close).
* ANON_REQ_TYPE_OWNER, firmware-ver removed (security exploit)
* ANON_REQ_TYPE_BASIC, formware-ver removed, just remote clock + some 'feature' bits
* CTL_TYPE_NODE_DISCOVER_REQ now ingored if 'repeat off' has been set
JakubandClaude Sonnet 5
Scott Powell
taco
ViezeVingertjes
Neil Alexander
Wessel Nieboer
terminalvelocity23
Scott Powell
João Brázio
realtag
Wessel NieboerandWessel Nieboer
liamcottle
Chris
Kevin Le
Florent