As @LitBomb pointed out in his [comment](https://github.com/meshcore-dev/MeshCore/issues/2118#issuecomment-4108168109) on #2118 RX Boosted Gain should not be enabled for the Station G2.
This change is a fix for #2124 to make the default of `radio.rxgain` to be OFF on the Station G2.
This restores the pre-1.14.1 behaviour with the only change being the user is now able to change the setting in the CLI.
Drive WB_IO2 (slot power switch) HIGH via early constructor before the
Arduino framework initializes. Without this, the board brownouts on
POE-only power because the slot MOSFET isn't enabled early enough for
the RAK13800 POE module to deliver power to the baseboard.
Also remove the W5100S hardware reset pulse from Ethernet init — the
chip comes out of power-on reset cleanly, and toggling reset kills
the PHY link which breaks POE power delivery.
Resolve conflicts: keep both Ethernet CLI and SenseCAP power-off
button code in repeater, keep both Ethernet docs and power management
CLI docs.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Add #pragma once to SerialEthernetInterface.h
- Rename TCP_PORT to ETH_TCP_PORT with #ifndef guard
- Fix typos: "initalizing" → "initializing"
- Fix #elif without condition → #else for STM32 block
- Replace infinite loop on ETH init failure with halt()
- Remove heartbeat Serial.print(".") output
- Remove dead beginETH() call (ETH_ENABLED, not RAK_ETH_ENABLE)
- Comment out MESH_DEBUG and ETH_DEBUG_LOGGING build flags
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Add W5100S Ethernet adapter support for RAK4631-based firmware, enabling
TCP CLI access on port 23 as an alternative to BLE/Serial connections.
- New SerialEthernetInterface for nRF52 with DHCP, reconnection handling,
and shared WB_IO2 power pin management with GPS module
- Ethernet build targets for repeater, room server, and companion firmware
- Prevent GPS from toggling WB_IO2 when Ethernet module is active
- CI build check for all three ETH firmware targets
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Support for R1 Neo hardware. New variant and baseboard class.
* Known issues:
- power management is not currently supported
- power off via long button press is not implemented
Add support for Epson Seiko RX8130CE I2C Real-time clock.
overkillfpv
SnaylerandGitHub
MGJ
fdlamotteandGitHub
Quency-D
Jeroen VermeulenandGitHub
Liam CottleandGitHub
KonstantinandGitHub
whywilson
Ryan Gregg
ripplebizandGitHub
Robert Ekl
João BrázioandGitHub
Wessel Nieboer
Sybren A. Stüvel
Ryan GreggandClaude Opus 4.6
Scott Powell
kelsey hudson
Sam Schlegel
Confi
Quency-DandGitHub