mirror of
https://github.com/MarekZegare4/MeshCore-Solo.git
synced 2026-07-26 14:58:12 +00:00
4999620fba
CMD_SET_RADIO_PARAMS and the on-device Settings radio editors (Freq/SF/BW/CR/Preset) called radio_driver.setParams() directly instead of applyRepeaterRadio(), so editing the companion's own radio params while relaying on a dedicated profile silently retuned the live radio off that profile. Both now route through applyRepeaterRadio(), the single decision point already used at boot and by the on-device repeater toggle. Also: overhear-suppression matched queued packets by payload hash alone, so it could cancel a queued direct-route retransmit that happened to share a hash with an overheard flood packet — now scoped to flood-queued entries only. repeaterProfileValid()'s frequency floor (100 MHz) is raised to 150 MHz to match the radio's actual validated range. RepeaterScreen's preset-name lookup now uses the same epsilon-tolerant float comparison as Settings instead of exact ==, avoiding inconsistent "Custom" labeling between the two screens. Dedupe: the BW-options table, the value-column x-offset math, and the default-profile-seeding block had each drifted into two or three independent copies (RepeaterScreen vs Settings, MyMesh constructor vs DataStore.cpp upgrade path); factored into shared helpers in RadioPresets.h / NodePrefs.h. Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>